Warrior S3002 FJ Cruiser Rear Flares (2007-2013 FJ Cruiser Manual do Utilizador descarregar pdf

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior Products, Inc.

16850 SW Upper Boones Ferry Rd

Ste. A

Durham, OR 97224

Phone (888) 220-6861

Fax (503) 692-0364

[email protected]

SUBJECT: Installation Instructions, S3002 FJ Cruiser Rear Flares

Before you begin this installation, you will need a few basic supplies. Only basic hand tools are required, and you

will need some protective tape such as blue painter’s tape. A molding removal tool may make some of this

installation a bit easier. Also, be aware that you may damage your retainer clips during removal of these outer

molding pieces, so you may need replacements from your local dealership.

1. Your first step will be to remove the

factory flare. This figure shows you

the attachment points. You will notice

that the rear most attachment points

are behind the rear bumper cover.

You will need to get the sides of the

rear bumper loose to access this, or

you can choose to completely remove

the front bumper.

2. Your new flare will attach to the

vertical holes in the lip that are on the

underside of the fender. Make sure

these holes are clear of any plastic

clips that may have not come out

during removal.

3. Now loosely bolt your steel flare into

place using the supplied hardware. For now, one bolt on each end and one in the middle should do. We

are just mocking it into place and you will be removing it again, so it is not necessary to put every bolt in

place.

4. With the flare in place, use your protective tape to create an outline of the top edge of the flare on the

vehicles fender. This is going to be your reference line onto which you will install the supplied P-shaped

trim.

5. With the tape outline in place, remove the flare and locate your P-Trim. The trim will install to the fender

with the top of the P directly under the edge of your tape line. You may need to make some pie cuts in

the flat part of the P in order to help turn the corners as the flare turns down the side.

6. With the P-Trim in place, you can now bolt your flare into place. Start by bolting it in loosely and put

inward pressure on the flare as you tighten.

7. Re-install your bumper, or re-secure the outer portions of it depending on how you proceeded in step 1.

For more information on other accessories for your FJ Cruiser, visit us online at www.warriorproducts.com

Resumo do Conteúdo

Página 1

Protecting Your Adventure Lifestyle========================================================================================QUALITY •

Comentários a estes Manuais

Sem comentários

Warrior S3002 FJ Cruiser Rear Flares (2007-2013 FJ Cruiser Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Para o carro Warrior S3002 FJ Cruiser Rear Flares (2007-2013 FJ Cruiser. Warrior S3002 FJ Cruiser Rear Flares (2007-2013 FJ Cruiser) User Manual Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com Para o carro Warrior S3002 FJ Cruiser Rear Flares (2007-2013 FJ Cruiser