Warrior 870 SAFARI REAR LIGHT BAR (2007 – 2013 Jeep JK Wra Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Para o carro Warrior 870 SAFARI REAR LIGHT BAR (2007 – 2013 Jeep JK Wra. Warrior 870 SAFARI REAR LIGHT BAR (2007 – 2013 Jeep JK Wrangler) User Manual Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 1
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 0
Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior Products, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone (888) 220-6861
Fax (503) 692-0364
SAFARI REAR LIGHT BAR
INSTALLATION INSTRUCTIONS
WAR 870
07’ & UP JK WRANGLER & UNLIMITED
Read all instructions before proceeding.
Due to welding, handling, shipping, etc., the Light Bar legs may need to be “adjusted” slightly
(bent in or out) to fit correctly. A small amount of twisting will not hurt the bar. Be careful
not to scratch the paint as you install the legs.
1. Remove taillights
2. Assemble the rear Light Bar by inserting lower mounting brackets onto the Light Bar hoop and inserting
snapper pins to hold in place. For a more permanent install we recommend the use of the included _” x 1
_” bolts, washers, and Nyloc nuts. The light tabs should be facing rearward.
3. Slide the rear hoop into the basket mounting tabs or rear of baskets. Position the rear bar assembly so
that both mounting brackets are even with the top of the body tub and the rear edge of the rear bracket is
approximately 5/8” rearward from vertical body seam. The two pairs of horizontal and vertical holes
should straddle the vertical seam and the vertical holes should straddle the horizontal seam. Make sure
the rear washer fits next to the inside body seams. Mark where the holes are to be drilled and then
remove the rear hoop.
4. On front mounting holes of the rear bar, you must drill through the inside panel.
5. Drill inside panel with a 1” hole saw, allowing room for socket.
6. Drill 3/8” holes where marked. Reinstall the rear Light Bar assembly. Install provided bolts through the
body tub using the reinforcing plates on inside tub and tighten loosely. Use of the bottom bolt on the rear
mounting brackets is optional to provide extra rigidity and does require installation of the backing plate
and nut from beneath the vehicle.
7. Reinstall taillights.
If you need further assistance installing your product, please contact us by email at
[email protected] or call us at (888) 220-6861.
THANK YOU FOR PURCHASING WARRIOR PRODUCTS
Vista de página 0
1

Resumo do Conteúdo

Página 1 - SAFARI REAR LIGHT BAR

Protecting Your Adventure Lifestyle========================================================================================QUALITY •

Comentários a estes Manuais

Sem comentários